Mi Onkyo
Records in this category (most clicks)
- Use Spotify (with Facebook login) with your Onkyo system
- Instead of Dolby TrueHD / DTS-HD the AVR only displays multichannel PCM?
- How can I play the TV sound through my A / V receiver?
- Problems after firmware update
- Resetting your AV receiver to factory defaults
- Which advantage has the ONKYO Universal Port?
- Can I use 7.1 av-receiver also with a 5.1 speaker system?
- The music service ... (AUPEO! / Last.FM / Napster / Spotify / vTuner) is not accessible
- HDMI interface of my AV receiver does not support 3D
- After a firmware update, the receiver does not operate correctly ?
- I have connected my PS3 to my new TX-NR509 and I can only get 'multi-channel PCM' to come up on screen. Whats going on ?
- Operation of the wireless Adapater UWF-1 in a WLAN with hidden SSID
- Sound and picture are out of sync - sound is played before the picture.
- I want to attach my Xbox 360 to my new TX-NR609 that I have just purchased ?
- I have tried all the codes in the manual but the Onkyo remote will still not operate my Sat Box , TV, Blu-ray player...
- How do I know if I am getting a Dolby TrueHD / DTS-HD signal ?
- What if I have problems receiving of digital DAB radio?
- Power LED blinks RED - system suddenly switches off (protect mode).
- I have a HT-S6405 and I do not want to mount the speakers on the wall, what stands should I use ?
- Using HDMI input with my receiver TX-SR 507 and above (576/577/605/606/607/...) and TX-NR 905/906 I do not receive an 5.1 audio signal?
- Which sources can be played through Powered Zone 2 (AVR Models 2011)
- Can I use Audyssey with only 5.1 speakers?
- My av receiver is far away from my screen and I have purchased a 10 m HDMI lead and I do not get any picture at 1080p but the onscreen menu from the av receiver works. Why is this?
- How much load can the 12V trigger output of the A / V receiver take?
- Firmware update cannot be done by oneself.
- On the back of the e.g. TX-NR809 a power of 710 W shown - the machine always consumes 710 W?
- Using HDMI I get no “OSD” on my screen?
- Operating Front High and Front Wide simultanesouly
- When using bi-amping mode does the av-receiver separate high and low frequencies for the single speaker terminals.
- I cannot access Spotify
- How can I use the Onkyo Wireless USB Adapter UWF-1?
- Are there any compatibility problems with Panasonic G10 and V10 series flatscreen TVs?
- Using AVR with Media Center PCs
- Firmware update failed - receiver reports an error.
- Only picture / no sound (HDMI Through enabled)
- Picture quality decreases with source connected via AV receiver in contrast to a direct connection to TV
- I have connected my PC/MAC and I am not getting a picture ?
- What we need to specify the speaker impedance?
- How do I set the speaker setup for my Bose Acoustimass system?
- Can I input an HDMI picture and convert to a component picture, until I upgrade my screen/protector.
- My receiver lost all it´s memory after disconnecting from ac mains?
- Can I control all my home theater equipment with the HDMI control?
- When I use the Audyssey set-up it fails when it gets to the right surround speaker in my 5.1 system, but I know I plugged them in.
- Can I use speaker output and pre out of the av-receiver at the same time?
- When I press Pure Audio mode the screen goes blank?
- How do I use the bi-amping feature of my receiver?
- Slight noise when Audyssey Dynamic Volume and EQ * (and other DSP modes)
- Onkyo Remote App for Android - supported AV receivers (as of 26-07-2011)
- What should I consider when calibrating with Audyssey?
- If sources are connected via HDMI to TX-SR 307/505E or TX-SR 506 I get no sound?
- I have an Xbox 360 Elite, when I plug in the HDMI I get picture but I do not get 5.1 audio, why?
- I have fed a signal to the AVR for Zone2 but I get no audio, why is this?
- Can I also use all channels each with xxx W continuous power?
- When I select 1080p on my TX-SR875/876, TX-NR905/906, PR-SC886 the image goes from my screen, but it does have a HD ready logo on it.
- How can I connect my old Onkyo MR system (multi-room, HE-10, HE-50)?
- Do I need a full home theater set-up to enjoy DVD-Audio?
- Is there anything to bear in mind then updating the TX-NR807 firmware?
- How much power consumption does the AVR use in standby mode?
- Which advantage has “Dolby Pro Logic IIz”?
- PS is only stereo (PCM) / Dolby Pro Logic - despite being connected by HDMI.
- Is it possible to use the av-receiver also in stereo mode?
- I have a TX-SR875/876, TX-NR905/906 or PR-SC886 and am running both the HDMI outputs but cannot seem to get a picture from both at the same time is my unit faulty?
- The remote control of TX-SR 505/507/577/605/606/607/etc cannot control my TV set, I have checked all pre program codes. Do you have other ones?
- Video Loss when playing PS3
- There is a USB input on the front of my TX-NR906, can I plug my iPod into it?
- Is upscaling possible at TX-SR 606/607 also with HDMI input signal?